New Module

[Niall Munnelly]

Perhaps an expander module that works with, say, two modules would be a cheap and effective solution. One could use it with both of your oscillators if they have them, and you wouldn’t need to make any major changes to your design.

Sent from a mobile device. Typos and probably bad ideas.

> On Apr 11, 2019, at 9:09 AM, paula at synth.net wrote:
> 
> Joost,
> 
> though that adds cost in terms of extra switches. It also means I may need a second PCB as this PCB is pretty full.
> I do try and bring out everything I can to the front panel, but eventually you have to draw a line somewhere :)
> 
> Paula
> 
>> On 2019-04-11 09:04, Joost Schuttelaar wrote:
>> On 11 Apr 2019, at 09:20, Jay Vaughan <ibisum at gmail.com> wrote:
>>>> Like the WTF there are jumpers on the back that allow you to disable the smoothing on the wavetables for each corner waveform should you wish.
>>> Jumpers?  Wouldn’t it be nice if they were on the front panel, and even Gate’able?  I could imagine flicking that switch mid-performance.
>> Alternatively, a push toggle switch next to the small pots under the
>> big wavetable pots. Choose for each corner, nice in a sequence! :)
>> watch those discontinuities though, simpler said than done :)
>> Cheers,
> _______________________________________________
> music-bar mailing list
> music-bar at lists.music-bar.org
> http://lists.music-bar.org/cgi-bin/mailman/listinfo/music-bar
> 
> Listen to Music-Bar Radio! <http://www.music-bar.org/radio.html>